Common problems and solutions during the use of automatic soldering machines

In the process of using the automatic soldering machine, some problems are sometimes encountered. These problems mainly include low precision of solder joints, virtual soldering, continuous soldering, tin cladding, tip drawing, and missing soldering, which are all bad phenomena for automatic soldering machine welding. These problems have some external factors besides debugging itself, then How to solve these problems? Below will list some of the problem and solutions.

Here is the content:

Common problems and solutions during the use of automatic soldering machines

1. The problem of leakage of automatic soldering robot during the welding process

Leakage of solder usually refers to the phenomenon that there is no tin on the pad during the welding process. The reasons for this phenomenon are: First, the tip of the soldering iron does not touch the solder joint. At this time, we need to adjust the coordinates of the solder joint so that the tip of the soldering iron touches the solder joint, so that there will be no leakage of solder. Another is that the surface of the pad is severely oxidized, and the tin cannot adhere at all.

2. The problem of virtual welding in the welding process of automatic soldering machines

Virtual welding usually means that the solder joints look normal during the welding process, but the welding strength is not high or the penetration of tin is insufficient. The main reasons for this are insufficient dwell time of the soldering iron tip on the pad or too low temperature. Therefore, we just need to prolong the dwell time of the soldering iron tip or increase the temperature.

3. The problem of continuous welding of automatic soldering machines during the welding process 

Continuous welding usually refers to the phenomenon that several solder joints are connected together during the welding process. The reason for this phenomenon is that the amount of tin delivered is too much or the gap between the two points is too small. In this case, the amount of tin should be reduced first, and then check whether the position of the soldering iron tip is correct, if not, it should be adjusted in time.

The above are the three common problems and solutions when using the soldering machine. For more about the soldering machine information, automatic tin wire soldering machine price. Welcome to contact us or visit our official website: Http://www.bbamachine.com/